10/08/2006, Sausalito, CA
Today, I got the solar panel mounted on the stern davits, with help from crew member John and a friend. This thing is about 5 feet by 3 feet. It's mounted on hinges so that it can tilt fore and aft about +/- 20 degrees. There are two locking piston-like devices that can lock the panel at any angle. These things are sold by West Marine for the purpose of adjusting the angle of an opening windshield on powerboats. They work perfectly.
I haven't connected the wires yet, since I'm awaiting the arrival of the charge controller, ETA Tuesday.
I also replaced the busted rope clutch on the mast for the jib halyard, going this time one size larger. Will add a block and cheek block so the halyard is brought into the cockpit.
Anderson's Boat Yard seems to be doing their thing at a snail's pace. So far the only thing they've done is pull the rig and remove the old prop and part of the prop shaft. I keep going into their office to remind them of our deadline.
Here's what Anderson's is expected to get done:
make bracket for the electric windlass, install chain stopper, dripless shaft seal, new prop and prop shaft, have diesel mechanic do complete engine service and checkout and recommend spares
Here's what we, the crew of Calou, still need to do:
finishing touches on bimini, solar panel, install windlass, cockpit shower, run jib halyard to cockpit, 2nd fuel filter & vacuum gauge in fuel line, new anchor rode, reconnect instruments
10/06/2006, Anderson's Boat yard, Sausalito
D.G. and I worked all day installing the emergency rudder system. It would have been easier, but the installation required the custom fabrication of teak shims to account for the curvature of the boat's hull. Fortunately, DG brought his table saw so the precise angle cuts were straight forward.
So now we have this great backup steering system!
Also today, Pascale drove all the way to hippie-dippee Hopland, CA, and back to pick up our new, super-duper solar panel. This baby produces 14 amps at 12 volts.That's a lot of power!
Attaching and connecting the solar panel will be the next project.
Started out this morning unstepping the mast of Calou, and hauling her out at Anderson's. We are pullling the mast to have access to the keel bolts, so they can be tightened.
Out of the water, a close inspection of Calou's hull showed she is in excellent shape, no blisters, and the bottom paint holding up fine since she was painted a year ago.
Calou will get a new prop shaft, a dripless shaft seal, a new cutlass bearing, and a new prop.
After some initial trouble, we got the Lewmar Pro 1000 windlass, which arrived today.
the new prop should've arrived today, but didn't. I won't start worrying until tomorrow.
I took the mains'l and genoa to Quantum Sails to be serviced, and am adding a deep third reef to the mains'l, so if we get some heavy weather, we can handle it.
I picked up the new SOS Emergency Rudder. This thing is a beautiful work of art, so finely designed and finished, it's a shame to bury it in a locker. This is probably the most important piece of safety equipment on board.
To top it off, we went to the Baja Ha-ha (Shouldn't they spell it Baja Ja-ja??) Crew party at Encinal YC. Met lots of sailors and cruisers there. Looks like a fun bunch. Crew members John and Deege joined us.
if you click on the "Current Position" map you'll be taken to a map of the West Coast showing our latest reported position. On the lower left corner there's a button that says "Google Earth".
If you click on that button, you'll be taken to Google Earth where you'll see an actual satellite photo of our location.
That is, depending on your computer setup. First, you need to have Google Earth installed (if you haven't already done so, it's free, so go to http://earth.google.com/ to get it).
Second, you need to configure your computer so that when it downloads a file called "calou.kml", it knows to open it using the Google Earth program.
If your computer downloads "calou.kml" but doesn't know what to do with it, just save the file to the desktop or some other place, and then open it using Google Earth.
There, I'm sure that's clear as mud .
This is a test of submitting blog updates via e-mail. This will permit sending via the Single Sideband radio when at sea or where there's no phone or internet service.
We've been working on preparations for this trip pretty much full time the last several weeks.
Here's what's been done or added recently (partial list):
6-man offshore Viking life raft, SSB radio, special modem and Sailmail, stern davits, motor crane, latches and gaskets on lazarettes, high output alternator, 5th battery for battery bank, total rework and modernization of 12V system, watermaker, new propane stove, new RIB dinghy and 8hp motor, 3hp motor for 2nd dinghy, window shades, custom bimini (thanks John), new dodger, overhaul diesel cabin heater...and the list goes on.
Here's what we still need to do:
electric windlass, chain stopper, new anchor rode, dripless shaft seal, new prop and prop shaft, have diesel mechanic do complete engine service and checkout and provide spares, finishing touches on bimini, solar panel(s), emergency rudder, cockpit shower, run jib halyard to cockpit, 2nd fuel filter & vacuum gauge in fuel line... and this list seems to keep getting longer!
10/01/2006, Tiburon, CA
We're starting this blog to chronicle our trip on Calou, our Ericson 38 sailboat, to sail down the coast of California and Baja, to Cabo San Lucas and points around the Sea of Cortez.
We're sailing as part of the 2006 Baja-Ha-ha, an annual rally from San Diego to Cabo. There will be some 182 boats going on this rally!
Our plans are, to not make plans. But we do know that we are due into San Diego about October 28, so as not to miss the Halloween party on the 29th, and the rally to Cabo departs from San Diego on October 30th. We are due to arrive at Cabo about November 10. After that, we hope to cruise around the Sea of Cortez for a while, maybe spend Thanksgiving in Mazatlan, and then head back up.
But as always in cruising, these plans are subject to change!