SailBlogs
Bookmark and Share
Issuma
La Plata
Richard
Thu Mar 5 17:10:49 EST 2009, La Plata, Argentina

La Plata is a small, relaxed college and refinery city SE of Buenos Aires. There is a good harbor with a fairly narrow entrance that opens up to a long stretch of totally protected water. There is a very friendly yacht club there, Club de Regattas, where we stayed for ten days.

Mon Mar 16 21:36:02 EDT 2009 | George
Beautiful picture, ... how are the new liferaft location and the new railing working out?
Tue Mar 17 16:10:03 EDT 2009 | Richard Hudson
The new liferaft location (not shown in this picture, on the port side of the keel) is so far working out well. The higher railing (instead of lower wire lifelines) is really nice, and makes getting around on deck much easier and more secure.
Wed Mar 18 10:15:35 EDT 2009 | George Ray
Liferaft: It seems that the improved visibility due to moving the life raft forward and lower would be a very big help and generally make for a nicer view.
Dingy: any changes in the dingy situation?
Reefing: How are the reefing methods evolving so far?
Ship in drydock
Richard
Wed Mar 4 0:00:00 EST 2009, La Plata, Argentina

Didn't catch the name of this ship in drydock in La Plata, but it looks impressive.

Finally sailing again!
Richard
Sun Mar 1 0:00:00 EST 2009, La Plata, Argentina

After three months of repairs and modifications, Issuma is finally sailing again. Still a bunch of things to finish, but it is really nice to have a boat capable of sailing again.

The picture was taken on a pleasant, sunny, daysail from Buenos Aires to La Plata.

San Isidro Cathedral
Richard
Mon Jan 26 0:00:02 EST 2009, San Isidro, Buenos Aires, Argentina

The cathedral in San Isidro, often used as a landmark when navigating in the Rio de la Plata.

San Isidro Cathedral
Richard
Mon Jan 26 0:00:01 EST 2009, San Isidro, Buenos Aires, Argentina

The cathedral in San Isidro, often used as a landmark when navigating in the Rio de la Plata.

Fitting the new day tank
Richard
Mon Jan 26 0:00:00 EST 2009, San Fernando, Buenos Aires, Argentina

The new day tank fits entirely into an existing access hole in the bottom of the cockpit. Nuts were welded to the underside of the steel cockpit bottom to bolt the tank to, and here the paint is being ground off in preparation for welding the nuts in.

New day tank
Richard
Mon Jan 26 0:00:00 EST 2009, San Fernando, Buenos Aires, Argentina

The "day tank" is a fuel tank that supplies the engine for a while (not really a day in this case), and is refueled from other tanks in the boat. The day tank simplifies switching between fuel tanks, and can be used to help separate out water and dirt in the fuel (being heavier, they sink to the bottom and can be removed if there is a drain at the bottom of the tank).

The old day tank was a cylindrical plastic affair, with fittings Sikaflexed (Sikaflex is a brand of glues and sealants) into it. It had been leaking, and the Sikaflex used to repair it was getting into the fuel and starting to clog the fuel filters.

I wanted a bigger day tank (the old one was only good for about three hours of motoring) that didn't leak and would help separate out the water and dirt from the fuel. This is the new day tank, made of stainless steel, much bigger, minus the fittings, which were installed after the tank was installed. The new tank is built to fit into an existing cutout in the cockpit floor.

The Disarray
Richard
Sun Jan 25 0:00:00 EST 2009, San Fernando, Buenos Aires, Argentina

There are a number of jobs going on at once on Issuma, and the pilothouse is now a mass of disarray.

Wed Jan 28 1:04:20 EST 2009 | george Ray
The pivoting instrument panel has a new white rectangle below the depth finder. What changes are happening there?
Wed Jan 28 11:33:45 EST 2009 | Richard Hudson
The GPS is being replaced. Sadly, the french GPS that came with the boat died. This likely happened when replacing the house batteries without disconnecting the solar panels, which spiked the voltage up.

The new GPS is a Furuno. The manual indicates there are data averaging settings that will will allow it to display believable courses and speeds like the old one did (unlike Garmins which never seem to do so correctly).
New pulleys for keel
Richard
Sun Jan 25 0:00:00 EST 2009, San Fernando, Buenos Aires, Argentina

The pulleys that are used by the winch to raise and lower the keel were badly corroded. The wire kept slipping off one of them, and two others were seized up and would not turn. All were replaced with new stainless steel pulleys with more grease nipples to make maintaining them easier.

Wed Jan 28 0:57:24 EST 2009 | george Ray
Hurray! Great to see the pulley system fixed up and easier to grease. Did you manage to get the cable soaked in hot tallow? I guess work is also happening to fix/improve the centerboard restraining pads.
Wed Jan 28 11:35:18 EST 2009 | Richard Hudson
Cable still needs to be replaced, and is still greasy. The bad keel pad had the bolts cut out and it was fixed (internal O ring failure) and reinstalled. Spare units did not fit the holes.
Something completely different
Richard/Victoria
Mon Jan 19 0:00:00 EST 2009, Buenos Aires, Argentina

The boatwork continues to progress on Issuma. The other night we went to see a really good band from northern Argentina, La Bomba del Tiempo. The band played outside on a hot summer night, and the crowd loved the band. The girl in the picture is one of several people who were being passed around through the crowd.

Sun Jan 25 17:15:50 EST 2009 | imeldita
guys, nice posting/picture! the colors... the exuberance it conveys. wish i could be there (not to sail per se...)
Wed Jan 28 11:36:48 EST 2009 | Richard Hudson
Buenos Aires is a really fun place (though a bit too hot in summer).

Newer ]  |  [ Older ]

 

 
Powered by SailBlogs