Thu, 06th March 2008, RPYC, Swan River, Perth, Western Australia
This afternoon I quickly popped down to the boat to check it out. I checked the bilge and found the normal amount of water in it, although I think it is time for me to clean the automatic bilge pump as I dont think it is starting automatically at the correct setting.
I also noticed that there was a bit of a layer of oil on top of the water. This is pretty normal for our old Italian Arona motor after a long journey under motor like what I did on Monday evening.
So, Saturday I will go down early to the boat before the race and clean the bilge out (quite an easy, but messy job), and clean the bilge pump as well. The bottom is starting to get a bit of slime on it (which is not good for racing) so Brett and I will give it a quick clean at the same time.
| Maintenance |
|
Comments [0]
Tue, 04th March 2008, RPYC, Swan River, Perth, Western Australia
I mentioned yesterday the RPYC are re-developing the marina. They are replacing 3 of the 5 hard jetties with floating jetties, as they have been around for many a long year and are desparately I need of replacement. Unfortunately our jetty (B) is not getting replaced, because it is pretty good condition.
So, as they are floating jetties there is no need for weights on the pile end of the mooring lines, and there are many spare just sitting on the club lawn waiting to be disposed of. I had noticed last week that we had lost a couple of our weights. The chain had probably rusted through and they dropped off. So, I went and checked with the Club Manager to see if I could take a couple of the ones from the old jetties.
Brett and I then only spent a couple of minutes hooking them on to the mooring line. Now the boat will move less in the pen when a bit o wave comes through.
| Maintenance |
|
Mon, 03rd March 2008, Swan River, Perth, Western Australia
This afternoon I decided to take Swagman out by myself to give the motor a good run, and get some real charge in the batteries. So, initially decided to head out from RPYC and head down the river to the Point Walter/Claremont area (about 30 min motor away at 5.5kts). The weather was really nice so I decided to continue down river around Point Walter, through Blackwall Reach, past East Fremantle and to the Fremantle bridges. Which I either turn around, drop the mast and continue on to sea (but I didnt have the gear on board to do), or smash into the bridge. So, I just turn around, although the temptation was to drop the mast and continue out into the ocean, and just go....but.....
There were quite a few boats out returning up the riverfrom Rottnest Island, but it was a very pleasant outing.
Got back about 7pm, and this was the first time I put the boat into it's pen at RPYC by myself. But the wind was kind and it was simple. The boat basically faces WSW in the pen, and we are will protected by the shore, but it is a shocker in anything north of east. Although the redevelopment of the marina will improve this with jetties being built further out to accommodate new pens and more boats, and this will protect us a lot more. Plus they are putting on wave attentuation devices to reduce the slop in the marina from NW'ers and passing boat traffic.
| Maintenance |
|
