Aisling I

We’re beginning to wonder if we’ll ever leave the dock. We hadn't planned to leave before the end of May anyway, but suddenly it’s the 29th and we’re not ready.

Mind you, a lot of things have been checked off the to-do list. New holding tank installed. New batteries purchased and connected. New life raft purchased and in place. Outboard motor serviced. Staysail furling gear installed. Genoa recut to make a #1 Yankee that can be flown with the staysail. Sails on. Decks scrubbed. Deck and lines washed…and washed again…and again…..

It’s the wind, you see. It’s blown ferociously, day after day; week after week. We get the odd break, and then it starts all over again.

Before Hans and Dani arrived, we gave the boat a thorough cleaning, as one does when one is expecting guests (and especially guests whose own boat is always spotless). Before they had even set foot onboard, the wind piped up and coated everything with a new layer of dust. Out came the dusting cloths and the hose and we cleaned everything again. The cycles of cleaning followed by big winds seemed to go on and on. The worst was about ten days ago, when we had a fierce wind from the east that coated our decks and lines in a thick layer of red dust mixed with salt. It worked its way below decks, leaving gritty dust on every surface. When the wind finally moderated, Rick spent an afternoon hosing everything off, but within a few hours it seemed like it was as bad as ever. We finally realized it was blowing off the upper sections of the rigging, which we had no hope of reaching with the hose. A good rainstorm is sorely needed, but even if that happens, it’s likely to carry more red dust with it.

One night last week, it blew sustained in the 40’s with gusts over 50 knots in the marina. We’d intended to go into town for dinner with Nancy and Bob, but a walk into town in those conditions didn’t really appeal to anyone. So we decided to cook onboard instead. What fun, cooking pasta with the boat heeled over as though we were sailing!

Yesterday, the weather was particularly odd. In the morning, it piped up from the east at about 30 knots. By early afternoon, it was dead calm, but an hour later, it was blowing over 20 knots from the west. On the dock, Mario the mechanic waved his arms in exasperation. “It comes from the left, then it comes from the right!” he said. He assures me that this is not at all “normale” for this time of year. Cold comfort for anyone hoping to do a passage.

Maybe we’ll be lucky. Our new wind generator will be installed early next week, and maybe a perfect wind will follow. I think we’ll wait to see which direction it comes from before we decide our destination!

Comments

Vessel Name:	Aisling I
Vessel Make/Model:	Slocum 43
Hailing Port:	Halifax, NS, Canada
Crew:	Rick and Bonnie Salsman
About:	Crew from Halifax to Horta: Bonnie and Rick Salsman, Dave Morse, Wally Fraser Crew from Horta to Spain: Bonnie and Rick Salsman, Al Salsman, Rob Salsman We left Halifax, N.S. in June 2007, sailed to Horta, and explored the Azores for a month. [...] More
Extra:	The info below is a copy and paste from some literature about the Slocum 43. Please excuse the platitudes. Although I may like them , they are not truly mine. Aisling I is a 1987 Slocum 43, designed by Stan Huntingford. She has been designed to satisfy the sailor who wants the blue water, "get [...] me there" ability with the amenities for great comfort at anchor and at sea. It's a combination of engineering, performance, comfort and safety, wrapped in high quality Burmese teak finish, teak and holly cabin soles and rich upholstery. She is meant to be easily handled by a couple under almost any conditions. She was built in Taiwan to exacting standards using some of the latest technologies of the time that are still admired today. LOA: 42'6" LWL: 35'10"" TYPE: Sailboat - Cutter Rigged BEAM: 12'11" DRAFT: 6' 5" BUILDER:SLOCUM DISPL: 28,104 lbs. SAIL AREA: 808 Sq.Ft. DESIGNER: Stan Huntingford BALLAST: 9,000 lbs. HULL MATRL: Fiberglass ENGINE: Perkins 4108 TANKAGE/FUEL: 120 gal TANKAGE/WATER:150 gal GENERAL INFORMATION: Naval Architect Stan Huntingford has incorporated into this sturdy double ender, both seaworthiness and ample interior space that offers steady and comfortable cruising. Below the water line, the hull shows a fine entry with a long cutaway forefoot followed by an efficient and modern keel section and a deep profile skeg hung rudder, just forward of a tapered stern section. This design combination readily separates the Slocum 43 from other traditional yachts and offers ease of handling and lively performance. This yacht is a perfect example of a classic offshore design and has a warm, roomy and comfortable interior . Incorporating a tumble home stern, bulwarks, dorades, opening ports, oversize rigging and quality construction, This yacht is a modern classic. ACCOMMODATIONS & LAYOUT: Headroom is 6'4" or better, throughout the boat and storage capacity can only be noted as "more than ample". Beautiful Burmese teak joinery throughout, solid teak staving , all doors are beveled and hand fitted, lockers are teak lined and the glossy varnished cabin sole is teak and holly plank. The interior is finished with a satin varnish with high gloss accents on the trim. Teak doors are louvered. This yacht sleeps up to six people in accommodations with the forward cabin, main salon and owners quarter berth cabin. The forward cabin design is a signature of the Slocum and incorporates an upper and lower twin bunk to port, with the top berth extending into a a settee and to port, there is extensive storage in the form of shelves, hanging locker, drawers and louvered doors. Naval Architect Stan Huntingford has incorporated into this sturdy double ender, both seaworthiness and ample interior space that offers steady and comfortable cruising. Below the water line, the hull shows a fine entry with a long cutaway forefoot followed by an efficient and modern keel section and a deep profile skeg hung rudder, just forward of a tapered stern section. This design combination readily separates the Slocum 43 from other traditional yachts and offers ease of handling and lively performance. This yacht is a perfect example of a classic offshore design and is one of the warmest, roomiest, most comfortable interiors available in a 43' cruising yacht. Incorporating a tumble home stern, bulwarks, dorades, opening ports, oversize rigging and quality construction, This yacht is a modern classic. Underneath the starboard countertop is a Stainless Steel automatic internal lighted freezer controlled by an opening top or door. Additionally, the refrigerator box opens from the front. The refrigerator and freezer have large capacity plates which were built to be easily removed for future servicing. There are 2-deep stainless steel sinks, fully gimbaled stove and generous counter space. Overhead cabinets have a moveable peg system, which allows you to custom fit spaces inside to the size and shape of your dishes. Over the galley is a large opening hatch for light and ventilation, also, there are two opening ports over the stove area for added ventilation. Directly across from the galley, to starboard, is a proper offshore, forward facing navigation station and chart table with tremendous room for an exceptional compliment of navigation and electronic equipment for easy use while navigating. The large nav table/desk has a generous storage locker under the desk top and room for the additional electronic navigation and communication equipment outboard. The nav seat is contoured for ease of use underway and the electrical panel is flush mounted here, on a swing-out door for easy access. Overhead are two additional opening ports for excellent cross ventilation with the galley and Nav area. Just aft of the nav station and to starboard of the companionway, is a large pilot berth that will be your favorite berth when offshore. There is a teak grate built into the teak and holly floor at the bottom of the companionway, to catch water from wet gear. With the wet locker and teak draining grate, which drains to the bilge, all foul weather gear is kept aft and away from the main living quarters. All locker doors are ventilated. At the bottom of the companionway stairs is additional storage behind bottom two steps. Next, to port is the owners aft cabin with a queen sized berth with storage below as well as drawers for him and her. Various shelves and locker with removable shelf and enclosed storage locker, as well as ample book storage and large teak framed mirror, mounted on the bulkhead. The aft stateroom also has excellent ventilation provided by two opening ports and an opening hatch overhead. There are 11 Stainless steel opening ports with screens and 5 opening deck hatches, plus the companionway hatch, with screens, which provides a tremendous amount of light and superior cross ventilation. There are also 2 dorade vents, one over the head and one over the chart table. Below deck ventilation far surpasses the standards in the industry. There are light colored curtains at the ports for privacy, interior cushions are a blue HULL AND DECK Hull hand laid-up Fiberglas with 20mm R62-80 Airex Sandwich. Cast iron ballast - 4.08 tonnes, flooded with resin and 100% glassed over ( encapsulated keel). Deck- hand laid-up Fiberglas with 3/4" Baltek balsa-wd sandwich core. Teak side decks - seasoned timber, quarter sawn with black bedding compound below and in seams, secured to Fiberglas by 1" sheet metal screws, countersunk and plugged. Inlaid teak on cabin top. 1 1/2" s/s shaft, tapered to ABYC std ELECTRICAL SYSTEM Conforms to United States Coast Guard and American Bureau Yachting regulations governing wire type, coding and load capacity FRP battery box, ventilated cover with quick release tie down NEWMAR (USA) electrical panel with panel light, circuit breakers with "ON" light and battery test switch, both 110v AC and 12v DC, volt Fuel tanks - New April2000, 120 gallons in 2 Aluminum 60 gal tanks with baffles, clean out ports, complete with dipsticks, inter tank connectors with valve, take off from top with s/s ball valve on each labeled and grounded More
Social: