Mostly as a way to bolster my standing among the cruisers of the world in terms of fortitude and technical expertise in the completion of boat projects, I'm happy to offer a brief summary of progress. Here's an annotated version of the list I posted in my
Winter Update post from early last February:
install the
new SSB [Installation complete, though I still have to commission it and learn how to use it.]
purchase and install
new refrigeration machinery [DONE! It's doing a great job of keeping food at much lower energy demands than the old unit!]
purchase and install a
new autopilot [About 3/4 done. All electronic components are installed and the mechanical portion that drives the actual rudder is about half done. If all that works, I'll still have to figure out how to interface with my navigation system.]
design, machine, and fit a double-pulley to drive the high-output alternator [Done, and working great. The old system used to squeal in protest when asked to charge the batteries, but the new system is very stoic. The new belts produced a fair amount of rubber dust in their first few hours of breaking in which I attribute to slight variation from the standard v-belt groove profile. They've stopped that now and I'm very pleased!]
pull and paint the masts and inspect structural components [Pulling and painting masts will still have to wait for the cheaper labor rates down in Mexico. I am also just plain out of time before departure on the Coho Ho Ho. I have inspected most of the chain plates on the starboard side, at least from the inside. They look pretty good and have bolstered my confidence in their integrity.]
sell one or both existing dinghies and replace with a
new Portland Pudgy [My friend Len bought the old RIB, although I had to invest $850 in engine repair to even put it on the market. The Grandy skiff has not attracted enough of the right kind of attention to give me much encouragement. I don't know what I'll be doing with her at this point. The new Portland Pudgy has been in service for a couple of weeks now, although delivery of the lifeboat canopy and the solar panel were back ordered. It's proving to be a fun little boat under oars and outboard, but I have yet to try out the sailing rig.]
add a second house battery to double available amp-hours [Done, along with the addition of a separate Comms battery and charging management system.]
test fit and, if necessary, reconfigure the emergency steering tiller [Done! I'm glad I did this, though it was only an educational process. I learned that I'll have to remove the wheel to give the tiller enough clearance for use.]
add a
Forespar whisker pole for the genoa and gennaker [Done, though yet to be used away from the dock.]
add another set of reefing points on the mizzen sail [I've decided this won't be necessary.]
replace the staysail and rig new sheets [The staysail has been replaced, but I've decided to stay with the old sheet system.]
add a storm jib. [Done.]
Of course, the list has expanded.