06 October 2007 | Grenada Marine
When we went to reinstall the saildrive Jay really wanted to do so by lifting the drive leg up from the bottom. The problem was the hull manufacturer cut a rectangular hole for a round drive plate. Almost, but not quite big enough. The laminate in the area that needed to be trimmed out was thin almost as if it was supposed to be cut out.
Jay is not shy. He grabbed a saw and started hacking on the hull. A moment later the hole was large enough to reinstall the drive leg from below (not to mention remove it from below next time!). This made reassembling the drive much easier.
Jay faired the newly exposed glass and gave it a good epoxy coating.